Welcome! Log In Create A New Profile

struggling to figure out color connections

Posted by AVRkire

AVRkire

struggling to figure out color connections
March 18, 2013 05:47AM

Registered: 13 years ago
Posts: 121

Hey everyone, building a Mendel using Ramps 1.4, my steppers are Kysan 1124090 motors.

They have the following colors and letters from the spec sheet:

A=Red
B=Yellow
C=Green
D=Blue

My Ramps board is asking for 2B, 2A, 1A, 1B

I am really confused on how I should connect my wires to my Ramps board, I have been reading many different things for different steppers.

Any help would be greatly appreciated! Thanks!

Reply Quote

Auzze

Re: struggling to figure out color connections
March 18, 2013 08:34AM

Registered: 16 years ago
Posts: 241

Hey..

Try
RED - 1B
Green - 1A
Yellow - 2A
Black - 2B

Auzze

Reply Quote

AVRkire

Re: struggling to figure out color connections
March 18, 2013 09:21AM

Registered: 13 years ago
Posts: 121

Auzze,

Thanks much for your reply!

Just to confirm, do you mean Blue to 2B?

My motors do not have a black, only a Blue.

Thanks!

Reply Quote

Andrew Smith

Re: struggling to figure out color connections
March 18, 2013 03:23PM

Registered: 15 years ago
Posts: 643

Wire them up. Test. If it doesn't move, swap pin 2 and pin 3. If the direction is wrong, reverse the connector or invert the axis in firmware.

Reply Quote

Auzze

Re: struggling to figure out color connections
March 18, 2013 03:39PM

Registered: 16 years ago
Posts: 241

AVRkire Wrote:
-------------------------------------------------------
> Auzze,
>
> Thanks much for your reply!
>
> Just to confirm, do you mean Blue to 2B?
>
> My motors do not have a black, only a Blue.
>
> Thanks!

Sorry, yes Blue

Auzze