RAMPS 1.4 NEMA17 TO NEMA23

Hello All,
Building a new printer mirroring Aluminatus Pro 1 first generation. In my build I want to use NEMA 23 steppers versus the NEMA 17 steppers.
I need to know what parameters I need to change in the configuration.H file to make this work.
I am relatively new to the 3d printing circuit as well as the RAMPS 1.4 environment.
Is this simply a matter of changing the voltage trim pot on the drivers?
Thanks any help here would be greatly appreciatted. I have been researching this for quite awhile to no avail.
Make On
Dwayne

the only changes you would have to make is if your new steppers have more or less steps per revolution 200 vs 400. other than that it would be just your trim pots on the drivers

---

[mike-mack.blogspot.com]