Welcome! Log In Create A New Profile

I have a question about the schematic for Ramps 1.4

parkerAVG

I have a question about the schematic for Ramps 1.4
February 13, 2014 01:09PM

Registered: 10 years ago
Posts: 2

Hello everybody! I'm new to the RepRap Project and this is my first post on the forum.

I had a question about this schematic:

RAMPS1.4schematic.png

is that chip (labeled U1 ARDUINO_MEGA_SHIELD) in the top left corner just the shield itself,(and if it is, where can i find a schematic to assemble the shield from scratch without a kit?)
OR is that just showing the arduino?

Parker Grant

Reply Quote

Cefiar

Re: I have a question about the schematic for Ramps 1.4
February 13, 2014 04:31PM

Registered: 14 years ago
Posts: 1,092

U1 is the connector on the shield that goes to the Arduino Mega. Basically it's easier for the schematic to treat the large Arduino Mega connector as a huge IC, This way you can place it wherever you want on the PCB when laying things out, the pins are all labelled for you, etc etc. Note that the pins IDs match the Arduino Pin IDs.

Reply Quote

parkerAVG

Re: I have a question about the schematic for Ramps 1.4
February 13, 2014 06:47PM

Registered: 10 years ago
Posts: 2

Thanks! this was a big help!

Reply Quote

bellami

Re: I have a question about the schematic for Ramps 1.4
April 09, 2014 10:03AM

Registered: 10 years ago
Posts: 45

Hello, I am new to the forum and wanted to ask where you can fix the file Ramps 1.4 for Fritzing or Eagle?

What I could find is for 1.3 Ramps

Thanks for the reply

Reply Quote

tjb1

Re: I have a question about the schematic for Ramps 1.4
April 11, 2014 08:38AM

Registered: 10 years ago
Posts: 553

Quote
bellami
Hello, I am new to the forum and wanted to ask where you can fix the file Ramps 1.4 for Fritzing or Eagle?

What I could find is for 1.3 Ramps

Thanks for the reply