Ramps1.4 Sprinter Config Problems
Posted by sharkyzer0
|
Ramps1.4 Sprinter Config Problems February 27, 2014 04:52AM |
So after finally getting everything built on my prusa mendel i3 and set up im now stuck on firmware 
. I have all the steppers able to move but cant print. I have no idea how to calibrate or where to go from here. Right now i am using Ramps 1.4 with sprinter and pronterface. Also i am using nema 17 stepper motors and pololu drivers if that additional information helps any.
. I have all the steppers able to move but cant print. I have no idea how to calibrate or where to go from here. Right now i am using Ramps 1.4 with sprinter and pronterface. Also i am using nema 17 stepper motors and pololu drivers if that additional information helps any.
Sorry, only registered users may post in this forum.