Quick questions- Might be normal but cant find anything while searching google or forums here and forums at reprapdiscounts.com(reprapdiscounts was the sellar I purchased these from)
Just finished building my second 3d printer
The motors seem to work fine
they move up and down back and forth like they are suppose too.
But something I have noticed when the printer is off no power from computer or power supply.
I move any axis and my lights on my ramps 1.4 board flicker on like they are getting power
They also come on on my endstops(red led)
Is this normal?\
Like I said everything working fine just something I am not used to seeing on my other printer
I am using ramps 1.4(newest
Taurino 2560 v3
Using 4 wire motors( Type 17PM-K502)
Other printer uses
Ramps 1.4- same board from reprapdiscounts just older (dont know if these have a certain rev number to them)
arduino
6 wire motors nema 17
Thanks for any help/tips/ feedback
Edited 2 time(s). Last edit at 04/14/2014 01:18PM by bladez.
