So my arduino 1.4 ramp burnt out the mosfet, and I have an azteeg x3 with the Y-axis stepper (aspect of the board) not working (it pulses). I do have a new power supply from the atx to a more suitable power supply for 3d printers. I do wonder if that might have need the problem, but at this point I am more than willing to change the pin configuration of the Marlin firmware.
From my understanding of posts and the marlin firmware the code to be changed is only within the pins.config file. I think azteeg x3 is mother board 67 (I would have to look up), so i searched for that and read over the config settings. It was unclear to me the separation between the pin settings for the extruders, and wanted to see if someone more skilled at changing these settings knew the best way to accomplish this.
I was wondering if anyone has don this or knows how to easily do this. I am not the best at electronics, so i wanted to start with some good advice and see where it goes...
Edited 1 time(s). Last edit at 04/20/2014 10:12PM by bishupz1.