Strange problem November 12, 2014 09:56PM |
Registered: 12 years ago Posts: 791 |
Re: Strange problem November 13, 2014 12:48AM |
Registered: 10 years ago Posts: 590 |
Re: Strange problem November 13, 2014 12:57AM |
Registered: 12 years ago Posts: 791 |
Quote
enif
Have you tried to lower the acceleration values on th Y-axis?
Re: Strange problem December 07, 2014 05:09PM |
Registered: 12 years ago Posts: 791 |
Re: Strange problem December 08, 2014 02:32AM |
Registered: 10 years ago Posts: 590 |
Re: Strange problem December 08, 2014 02:38AM |
Registered: 12 years ago Posts: 791 |
Re: Strange problem December 08, 2014 05:31AM |
Registered: 10 years ago Posts: 590 |
Re: Strange problem December 08, 2014 08:40AM |
Registered: 12 years ago Posts: 791 |
I guess that is the next try. Thanks for the idea.Quote
enif
If you swap the entire electronics (Mega+Ramps) with the one of your own printer ... does the problem move with the electronics or stay with the printer?
Re: Strange problem December 08, 2014 07:23PM |
Registered: 12 years ago Posts: 791 |
Quote
regpye
I guess that is the next try. Thanks for the idea.Quote
enif
If you swap the entire electronics (Mega+Ramps) with the one of your own printer ... does the problem move with the electronics or stay with the printer?
Re: Strange problem December 09, 2014 01:36AM |
Registered: 10 years ago Posts: 590 |
Re: Strange problem December 12, 2014 09:45PM |
Registered: 12 years ago Posts: 791 |
Quote
enif
Well, at least you now ruled out any mechanical problem in the printer itself...
Were you running the tests with your original firmware or have you tested with the "cloned" firmware from the faulty controller?