X channel dead can i remap to E1 ( unused extruder
March 06, 2015 12:32AM
HI
Just received a Ramps 1.4 board ( for my second build)and the x stepper channel doesn't work.
I've tried swapping out the driver and stepper with one that works etc but no luck still dead. Measured the voltages and all looks OK but the resolution on my multi-meter doesn't really hack it when it comes to pulses.

So i thought maybe i could configure it to use E1, the second extruder channel ( that does work fine but i dont need ) as my X channel.

Anybody done this before ?? IS it possible ??
I guess it will take some modifying in config.h & pins.h but would appreciate any info

Thanks in advance
Sorry, only registered users may post in this forum.

Click here to login