Welcome! Log In Create A New Profile

Advanced

Marlin / Arduino 1.0.6 resetting after several LCD inputs

Posted by RRuser 
Forum List Message List New Topic
RRuser
Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 20, 2015 06:17PM
An ongoing event is occurring, whereby when inputting several LCD inputs (especially move axis - extruder), that ramps resets itself. This is a new install, and using LCD only. Is there a buffer somewhere that is filling up?
Reply Quote
o_lampe
Re: Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 21, 2015 03:08AM
1.06 is a development version?
Maybe worth, claiming an issue in their github branch.
-Olaf
Reply Quote
Wurstnase
Re: Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 21, 2015 04:53AM
Quote
o_lampe
1.06 is a development version?
Maybe worth, claiming an issue in their github branch.
-Olaf

Arduino IDE 1.06 winking smiley

Triffid Hunter's Calibration Guide --> X <-- Drill for new Monitor Most important Gcode.
Reply Quote
RRuser
Re: Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 21, 2015 06:15AM
Well it's old enough that I thought everyone would know of it's simple problems. I need it for XP, since the newer one would not work.

Anyway, I'm sure it's not supposed to reset after just a few fast LCD knob twists.
Reply Quote
enif
Re: Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 21, 2015 08:01AM
Might there be a problem with your LCD drawing too much current (e,g, for its backlight) from the Mega's 5V regulator?
Reply Quote
RRuser
Re: Marlin / Arduino 1.0.6 resetting after several LCD inputs
August 21, 2015 12:33PM
Since the light is continuously on, with no problem, and only resets if you twist the control knob a lot, could this really be the power supply? Especially if it was a kit and everyone else's works fine.
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login