Err: MINTEMP

Hi,
im building a prusa i3 rework, iv uploaded Marlin (http://reprap.org/wiki/Prusa_i3_Rework_Firmware/pt) i get, min temp error.
then iv downloaded another firmware (https://github.com/MarlinFirmware/Marlin) and i get max temp error.

i try 2 thermistors and i get readings about 130k. iv used a multimeter to check between the 2 pins on ramps to thermistor and get 4.98V, on config i have #define TEMP_SENSOR_0 1

Please help :p

Best regards from Azores

Edited 1 time(s). Last edit at 02/15/2016 08:09PM by zibo.

Max_temp error indicates a shortcut in the thermistor wires or on the Ramps.

hi o_lampe,
but with newst version of marlin i get min temp error!