Welcome! Log In Create A New Profile

Not sure what settings control drift per layer

Posted by Nate_Bro

Nate_Bro

Not sure what settings control drift per layer
November 08, 2016 01:16PM

Registered: 11 years ago
Posts: 13

So yesterday I made the yellow part on the left, the part is skewed so I adjusted the machine, and adjusted the z Axis I had it set to 500, it should have been 2500 since I had to manually adjust the layer height. So after getting everything set right I tried to print again, this time at 50% to conserve marital. It seems that after each layer the drift is doubled.

Reply Quote

Attachments:
open | download - 20161108_121128.jpg (157.1 KB)

o_lampe

Re: Not sure what settings control drift per layer
November 09, 2016 10:40AM

Registered: 9 years ago
Posts: 5,232

Raising z-steps by a factor of 5 is weird. I'm sure you have an error in your calculation. Tell more about the stepper, driver, microstep-jumpers, pulleys or leadscrew dimensions.

When you've sorted this out, the next step is adjusting the Vref to get the stepper current right.

Edited 1 time(s). Last edit at 11/09/2016 10:42AM by o_lampe.