Hi
After reading that large prints were best left uncooled at first to avoid warping I tried to alter the fanspeed through the tune menu whilst printing.
The Cura setting had always been set to be slower at first, building up to 100% at 0.5 mm height.
No luck adjusting it manually.
This got me quite worried.
Just now I tried some prints where I've told Cura, the new version 14.07, to slow the fan down at first.
Still, the fan is at 100 percent (or so I think) all the time.
From the moment I turn the entire machine on, to the moment I start printing.