Welcome! Log In Create A New Profile


3D Printer problem

Posted by UniC 
3D Printer problem
March 14, 2017 10:52AM
We've built a Delta Printer from scratch and we are almost done until we hit a roadblock a few days ago. Apparently the RAMPS has been drawing too much power from the Arduino.
also we were able to connect the Raspberry Pi to the Ardunio but we get a message of "Error: Failed to auto detect serial port, please set it manually"
Any ideas? Thanks!
Re: 3D Printer problem
March 14, 2017 11:23AM
... could be the 5V regulator on the Arduino is overloaded - add an external +5V source with higher amperage ...

Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]
Re: 3D Printer problem
March 23, 2017 07:39AM
If RAMPS has really drawn to much current, there ist 99.99% that the voltage Regulator of the Ardruino is broken, and killed the MEGA2560 - You would have to buy a new one.
Sorry, only registered users may post in this forum.

Click here to login