Need help with axis movement parameters May 05, 2017 05:28PM |
Registered: 7 years ago Posts: 17 |
Re: Need help with axis movement parameters May 05, 2017 06:08PM |
Registered: 7 years ago Posts: 759 |
Re: Need help with axis movement parameters May 05, 2017 07:30PM |
Registered: 7 years ago Posts: 17 |
Quote
obewan
Under the stepper drivers on the ramps board are 3 pairs of jumper pins for setting the micro stepping. Some ramps board have these jumpers pins shorted so it is permanently in 1/16 micro stepping.
If so, you will need to do a lil surgery on the said tracks.