I bought a geeetech extruder and I am trying to figure out how to wire the stepper motor to a ramps board. The motor is 42shd0217-24b. Can't seem to figure it out.
I am using this ramps, [www.makerfarm.com]

NVM

Edited 1 time(s). Last edit at 05/13/2017 10:49PM by Antslake.

BBC

---

_______________________________________
Waitaki 3D Printer

See wiring

[www.casunmotor.com]


[reprap.org]

[reprap.org]

From left to right, wire all of the stepper motor's wires as red, blue, green, and black
or red, green, yellow, blue into the pins next to the Pololus

.