Welcome! Log In Create A New Profile

z probe ignored

huskies62

z probe ignored
January 20, 2018 02:30PM

Registered: 6 years ago
Posts: 3

I have a NPN probe for leveling. It shows at triggered but does not stop movement in either direction. It shows as triggered when it should and open when it should. Running ramps 1.4 on a Anet A8. Any help would be greatly appreciated

Edited 1 time(s). Last edit at 01/20/2018 02:31PM by huskies62.

Reply Quote

Roberts_Clif

Re: z probe ignored
January 20, 2018 03:11PM

Registered: 6 years ago
Posts: 1,863

Have you install new firmware or it this a stock machine. More information may assist us in helping you.

Reply Quote

huskies62

Re: z probe ignored
January 20, 2018 07:04PM

Registered: 6 years ago
Posts: 3

Oops sorry. I have installed Marlin 1.1.8

Reply Quote

Roberts_Clif

Re: z probe ignored
January 20, 2018 07:25PM

Registered: 6 years ago
Posts: 1,863

What settings do you have for your Mechanical end-stops "COM to ground and NC to Signal uses "false" here (most common setup)"

Reply Quote

huskies62

Re: z probe ignored
January 20, 2018 11:20PM

Registered: 6 years ago
Posts: 3

I finally got it. I had to home it. I either missed that or didn't get to that part of the instructions. Thanks for at least trying to help smiling smiley