Controller output issue June 05, 2018 09:36PM |
Registered: 6 years ago Posts: 52 |
Re: Controller output issue June 05, 2018 10:22PM |
Admin Registered: 13 years ago Posts: 7,000 |
Re: Controller output issue June 06, 2018 09:03AM |
Registered: 6 years ago Posts: 1,863 |
Re: Controller output issue June 06, 2018 10:11AM |
Registered: 6 years ago Posts: 52 |
Re: Controller output issue June 06, 2018 08:08PM |
Registered: 6 years ago Posts: 1,863 |
Re: Controller output issue June 06, 2018 08:18PM |
Registered: 6 years ago Posts: 52 |
Quote
Roberts_Clif
I quickly went through the code in the pins_MKS_13.h
* Arduino Mega with RAMPS v1.4 adjusted pin assignments
*
* MKS v1.3 (Extruder, Fan, Bed)
* MKS v1.3 (Extruder, Extruder, Fan, Bed)
* MKS v1.4 (Extruder, Fan, Bed)
* MKS v1.4 (Extruder, Extruder, Fan, Bed)
And the it call pins_RAMPS.h
I am confident that this is what will address the Extruder, Extruder, Fan, Bed for my Controller board.
Re: Controller output issue June 07, 2018 09:45AM |
Registered: 6 years ago Posts: 1,863 |
Quote
Cougar281
Quote
Roberts_Clif
I am confident that this is what will address the Extruder, Extruder, Fan, Bed for my Controller board.
Sounds good - that gives me hope that it'll address mine too. My printer is currently 11 hours into a print with 1.5-2 to go - once that's done, probably tomorrow morning, I'll flash the new code to it and see what I get.
Re: Controller output issue June 07, 2018 10:04AM |
Registered: 6 years ago Posts: 52 |
Re: Controller output issue June 07, 2018 10:57AM |
Registered: 6 years ago Posts: 1,863 |
Re: Controller output issue June 07, 2018 11:26AM |
Registered: 6 years ago Posts: 52 |
Re: Controller output issue June 07, 2018 06:53PM |
Registered: 6 years ago Posts: 1,863 |