Hello everyone
Building a 3D Printer, using Marlin-1.1
every time I try to print, The extruder does not heating up "stays at room temperature" , while the heatbed heating up, but after 10 minutes an error appears
Error:Heating failed, system stopped! Heater_ID: bed
[ERROR] Error:Heating failed, system stopped! Heater_ID: bed
Error: Printer halted. kill() called!
[ERROR] Error: Printer halted. kill() called!
when I turn on the bed and extruder from the software, the extruder reaches the temperature that i need, while the bed keep heating up until that the same error appears "after around 10 min"
Edited 1 time(s). Last edit at 10/23/2019 07:56PM by 3bdelli.