Welcome! Log In Create A New Profile

BLTouch and RepRap Ramp 1.4 wiring

richwfowler

BLTouch and RepRap Ramp 1.4 wiring
December 29, 2019 06:03PM

Registered: 4 years ago
Posts: 1

I've been searching, but have not found a clear answer. I am installing a BLTouch on a RepRapGuru printer which has a RAMP v1.4 board.
Can anyone fill me in as to which BLTouch wires connect to which pins on the board?

I *think* the 3 wire (brown,red,orange) wire connect to the servo pins at D11.
I also thing the 3 wire(black, white) go to the z_min connector (the ground and signal pins).

Reply Quote

Dust

Re: BLTouch and RepRap Ramp 1.4 wiring
December 30, 2019 03:48AM

Admin
Registered: 13 years ago
Posts: 7,001

Ramps%201.4.jpg

The 5v jumper circled is required.

Edited 2 time(s). Last edit at 12/30/2019 05:08AM by Dust.