Hello all i`m new to the forum and have a burning question
i`m using Marlin 1.1.8? and this is my setup

Anet A8 with MKS gen 1.4 board
Using the DRV8824 Drivers
Dual Z Axis
Standard heatbed

Z1 Does work but turns much slower than Z2
Also in the configuration.h i have set the motherboard to

#define MOTHERBOARD BOARD_MKS_13

#define Z_DUAL_STEPPER_DRIVERS
#if ENABLED(Z_DUAL_STEPPER_DRIVERS)
  //#define Z_DUAL_ENDSTOPS
  #if ENABLED(Z_DUAL_ENDSTOPS)
    //#define Z2_USE_ENDSTOP _XMAX_
    #define Z_DUAL_ENDSTOPS_ADJUSTMENT  0
  #endif
#endif

Both of the motors work
Drivers are OK and checked but Z1 is moving much slower than Z2
Please advise if i have missed something

With kind regards from the netherlands.

3-mal bearbeitet. Zuletzt am 01.06.18 18:02.