Welcome! Log In Create A New Profile

Need Printed Parts

Posted by Mal

Forum List Message List New Topic

Mal

Need Printed Parts
October 22, 2012 07:57PM

Registered: 11 years ago
Posts: 9

Can any one print me up the pats for an ORB BOT Hadron?

Cheers Mal

Reply Quote

gazob

Re: Need Printed Parts
October 23, 2012 01:02AM

Registered: 11 years ago
Posts: 98

Ordbot hadron does not have any printed parts, unless you are talking extruder, they are all lasercut acrylic or water jetted alu.

Much of the design strength comes from this fact but I suppose you could print parts, do you have the stl's?

GaZ

Reply Quote

Mal

Re: Need Printed Parts
October 23, 2012 01:12AM

Registered: 11 years ago
Posts: 9

My mistake I was not aware of this. The postage from ATI was not all that bad so will just go with them.