For Sale - Prusa I3
Posted by Spruce goose
|
For Sale - Prusa I3 February 23, 2014 12:39AM |
Hi all, I have a single plate Prusa I3 for sale,
Features
- Heated Bed 12V Mk 2
- Heat glass
- GT2 pullies and belts
- Spool holder
- 4x spools of ABS (Black, Gold, Clear, Blue)
- 2x rolls of 40mm kapton tape (for the bed) and 1x 10mm kapton roll (for hot ends)
- ATX power supply
- M10 Y Axis threaded rods, M8 stainless smooth rods with LM8UU bearing
- External screen controller with SD card (can print without the computer)
- Autocalibration Z axis servo/switch (used to autocalibrate the bed)
- Single plate metal frame - very solid
- 0.5mm jhead mark V
- Plastic Y carriage assembly instead of rods, stiffer, less metal parts, and better tensioner link
- Quality LearCNC RAMP/Motor kit including screen link
Has been a great printer, printed quite a bit of stuff with it, has been especially good with the recent autocalibration add on, saves hours of time in calibrating the bed before printing.
Only looking to sell this unit to fund the challenge of building a delta printer so I can do taller prints
Happy to throw in a couple of hours of support to get you going if its your first machine.
Easily $900 of parts in the unit
Sell for $600, prefer local (brisbane northside) pickup as its easier to transport and for training, but will ship for extra.
Cheers
Goose
Edited 4 time(s). Last edit at 02/23/2014 04:50AM by Spruce goose.
Features
- Heated Bed 12V Mk 2
- Heat glass
- GT2 pullies and belts
- Spool holder
- 4x spools of ABS (Black, Gold, Clear, Blue)
- 2x rolls of 40mm kapton tape (for the bed) and 1x 10mm kapton roll (for hot ends)
- ATX power supply
- M10 Y Axis threaded rods, M8 stainless smooth rods with LM8UU bearing
- External screen controller with SD card (can print without the computer)
- Autocalibration Z axis servo/switch (used to autocalibrate the bed)
- Single plate metal frame - very solid
- 0.5mm jhead mark V
- Plastic Y carriage assembly instead of rods, stiffer, less metal parts, and better tensioner link
- Quality LearCNC RAMP/Motor kit including screen link
Has been a great printer, printed quite a bit of stuff with it, has been especially good with the recent autocalibration add on, saves hours of time in calibrating the bed before printing.
Only looking to sell this unit to fund the challenge of building a delta printer so I can do taller prints
Happy to throw in a couple of hours of support to get you going if its your first machine.
Easily $900 of parts in the unit
Sell for $600, prefer local (brisbane northside) pickup as its easier to transport and for training, but will ship for extra.
Cheers
Goose
Edited 4 time(s). Last edit at 02/23/2014 04:50AM by Spruce goose.
Sorry, only registered users may post in this forum.