BronzeFill now in stock 1.75mm and 2.85mm
Posted by wilsonj
|
BronzeFill now in stock 1.75mm and 2.85mm July 23, 2014 07:32PM |
We now have the new ColorFabb Bronzefill filament in stock, in limited quantities. Really amazing stuff!
Here is a bunny I printed at 80 micron, then polished with steel wool and Brasso.
[www.3dprintergear.com.au]
We also have PolyMakr PolyMax, which is stronger than ABS without the brittleness usually associated with PLA. I've had reports that support is also easier to remove. PolyFlex also available next week.
[www.3dprintergear.com.au]
Cheers
Jamie
Here is a bunny I printed at 80 micron, then polished with steel wool and Brasso.
[www.3dprintergear.com.au]
We also have PolyMakr PolyMax, which is stronger than ABS without the brittleness usually associated with PLA. I've had reports that support is also easier to remove. PolyFlex also available next week.
[www.3dprintergear.com.au]
Cheers
Jamie
Sorry, only registered users may post in this forum.