Welcome! Log In Create A New Profile


Problems on using support material

Posted by NorthStar 
Problems on using support material
February 27, 2012 08:04AM
Hi All!
I am using Prusa with skeinforge. I already have good results on common prints, but on complex like this [www.thingiverse.com] I have a big problem. When I turn Raft with support material on I have a orbit after every layer. It is not only very slow, but also I miss a big part of the perimiter after each orbit, so quality is very bad. What can help me?
How to turn Orbiting after Raft Off??
Is it possible to make this Orbiting very fast?
Is it possible to do some extrusion after orbiting? I try Restart Extra Distance, but it works on every layer of the object, and orbiting is only on every layer of support.
Please help.
Re: Problems on using support material
February 27, 2012 02:26PM
It sounds like a temperature issue
set support material temperature at the same value than the rest
Sorry, only registered users may post in this forum.

Click here to login