I am having a hard time figuring out what i need to change, first off my nozzle is fairly blunt and it drags and plastic around that is not in place properly and makes a bigger mess, i am going to machine the nozzle to be more pointed. But other than that i have attached a picture of my first 3 20mm boxes (left to right is the order they were printed) and they look awful to me, i have also attached a screen shot of my slic3r settings.
I have calibrated all 3 axises and the extruder's steps per mm to +/- .03mm
the first layer looks good (see attached), then it gets progressively worse each layer
any thoughts?
Edited 2 time(s). Last edit at 04/11/2012 09:46PM by c172cpt.