Welcome! Log In Create A New Profile

Advanced

Advise on printing problem (blobs in corners)

Posted by Enlightx 
Forum List Message List New Topic
BAMCNC
Re: Advise on printing problem (blobs in corners)
September 27, 2012 09:41PM
I have a similar problem, hoping to try these fixes. I also made a longeraluminutubebetween my hot end tip/heater and the plastic insulating barrier on the extruder, its a budaschanozzle , so far I think it helped to pre heat the plastic
Reply Quote
Page 2 of 2    Pages: Previous12
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login