Hi, this if my first build, a Prusa i3 Rework from Replikeo. After dealing with the hassle of ABS, i'm switching to PLA, and i've been tuning the parameters as best as i can based on tutoriales for Slic3r, Extruder calibration, etc.
Everyhing seems somewhat ok, except that when the infilling is being done, it does so in an intermittent fashion. Meaning that using rectilinear infill, it spills lets say 6 lines, then no more plastic for 2 or 3, then 6 more ok and so on. I think it can be appreciated in the image i'm uploading.
¿Any thoughts?
Thanks!
Edited 3 time(s). Last edit at 09/21/2014 05:29PM by Bugo.