Welcome! Log In Create A New Profile

Can anyone spot the slight problem with this print?

MotoBarsteward

Can anyone spot the slight problem with this print?
July 04, 2012 01:21PM

Registered: 14 years ago
Posts: 283

Unattended prints have their drawbacks!

A Problem

Using ABSPrusa Mendel Zaphod with Pronterface and slic3r 1.3.0. Printing well with 3mm PLA and ABS through 2 x J Head Mk IV b and Wade Geared Exruders. Controlled using RAMPS1.4 board running Marlin_v1.1.9

Reply Quote

NewPerfection

Re: Can anyone spot the slight problem with this print?
July 10, 2012 02:35AM

Admin
Registered: 17 years ago
Posts: 1,472

Haha, I've had that happen before. Even worse than that. Back before stepper extruders when the extruder was on/off, and Windows decided to update in the middle of the print. Of course the print stopped with the extruder running, so it just kept going and going. Made a huge mess of plastic.

Reply Quote

MaFraL

Re: Can anyone spot the slight problem with this print?
July 11, 2012 08:03PM

Registered: 14 years ago
Posts: 52

Well, that's horrifying. I haven't had that problem yet. confused smiley