Hi,
I started yesterday with printing a new dual-E3D carrier. [
www.thingiverse.com]
Every part went well, but the bracket for the lm8uu bearings turned out as a nightmare.
I got strings because the semicircles do not connect to the print.
Nozzle: 0.4
Layer 0.3
I tried to print it with 2.4mm shell size or 0.8 mm shell size. Even at 30mm/s with 210C, I couldn´t make it bond to the print.
I printed it upright, like it is shown in the picture. Should I try it flat, with support?
-Olaf
Edited 1 time(s). Last edit at 07/07/2015 11:15AM by o_lampe.
Attachments:
open |
download -
dual_e3d_bracket.jpg
(186 KB)