blobbing during layer change/nozzle cool down

Hi folks,
Just experimenting with kisslicer and have a problem i knew would occur.
During the cooling of the nozzle between layer 0 and 1, i am getting a blob
of abs on the print.

Is there a elegant way to deal with this? Say, moving the nozzle, during
adjusting the temp, to an unoccupied part of the bed to dribble there.

Any suggestions?

Andrew

With ABS it is usually suffcient to do a small retract.

---

[www.bonkers.de]
[merlin-hotend.de]
[www.hackerspace-ffm.de]

kisslicer waits for the hot end to cool down? That's an unusual choice.

Just seems to be what it does going from layer 0 to 1.

Though slic3r seems to be able to cool on the run and not pause
anywhere near the same time.