Hey guys, im trying to configure my Marlin Firmware to upload to my prusa I3. I have a question:
I have a MKS Base controller board for my printer so i have the lines:
#ifndef MOTHERBOARD
#define MOTHERBOARD BOARD_MKS_BASE
#endif
BUT in the arduino IDE Tools > Board >
there is no option to select an MKS Base...
what do I do?
thanks guys, im a total noob when i comes to this marlin stuff. Appreciate all the tips!!!!
#### Edit
Fixed everything, let this die.
Edited 2 time(s). Last edit at 07/15/2016 10:37PM by davidbananas999.