Welcome! Log In Create A New Profile

Advanced

Little blobs all over

Posted by smb1985 
Little blobs all over
August 19, 2012 12:31PM
So I've been doing a few prints with decent success, but I keep getting these little blobs, especially in the first few layers, that cause problems in subsequent layers. I'm using a .35mm j-head hot end, RAMPS 1.4, marlin firmware, and ABS
Attachments:
open | download - 2012-08-19_11-12-40_886.jpg (292.5 KB)
Re: Little blobs all over
August 19, 2012 12:37PM
Just throwing an idea out, since it doesn't happen in later layers, could it be a result of the z-home being too low?
Re: Little blobs all over
August 19, 2012 02:41PM
I would be incline to agree assuming, that is, that your extruder is calibrated correctly.


Using ABSPrusa Mendel Zaphod with Pronterface and slic3r 1.3.0. Printing well with 3mm PLA and ABS through 2 x J Head Mk IV b and Wade Geared Exruders. Controlled using RAMPS1.4 board running Marlin_v1.1.9
Re: Little blobs all over
August 19, 2012 03:00PM
That does indeed look like you have the first layer too low.


Cameron

Help improve the RepRap wiki!
Just click "Edit" in the top-right corner of the page and start typing.
Anyone can edit the wiki!
Sorry, only registered users may post in this forum.

Click here to login