I was using firmware 2.05.1 before, but yesterday updated to 3.1.1, tuned PID for hotbed (M303 H0 S100) just in case and did test print. First I noticed that PID settings for hotbed were different, in v2.05.1 it was (F20 added by me as recommended, 600W silicone heater with SSR)
M307 H0 A237.8 C782.6 D13.4 F20 S1.00 V24.3 B0
but after tuning and saving in v3.1.1 it became
M307 H0 A102.7 C778.3 D11.5 S1.00 V24.3 B0
Line after tuning
M307 H0
Heater 0 model: gain 102.7, time constant 778.3, dead time 11.5, max PWM 1.00, calibration voltage 24.3, mode PID
Computed PID parameters for setpoint change: P117.6, I1.243, D946.8
Computed PID parameters for load change: P117.6, I3.126, D946.8
The problem is lines are back as shown on picture: from left to right - green and white with PID tuned in v3.1.1, rightmost when I changed M307 in sys\config-override.g to made in v2.05.1 (PLA, 220C, bed 70C). As you can see there is problem in v3.1.1 autotuning.
Attachments:
open |
download -
IMG_20200831_211918-min.jpg
(410.1 KB)