I have an MKS Gen L V1 board with Bugfix 1.8 something. It always turns on when the temp reaches 50C, at 255 speed.
My extruder fan stopped working, for the life of me i can not think of what changed.I did, however, install a filament detector but the install was fairly innocuous. To test the fan and circuit, I ran
M43 T I L7 R100 S7 W100 which runs a pin debug. The fan pulsed on - so I know that the fan is good. It has to be something in Marlin am I correct? What direction would you go next? I attached my config and config_adv files. My wife wants me to print some Reindeer Christmas cards so I am under the gun
Thanks.
Pulsing PIN: 7 Port: H4 FAN1_PIN Output = 0 TIMER4B PWM: 0 WGM: 1 COM4B: 0 CS: 3 TCCR4A: 1 TCCR4B: 3 TIMSK4: 0
MOSFET_D_PIN Output = 0
Done.
OK
Edited 2 time(s). Last edit at 12/06/2021 10:32PM by ELHEFE.