Welcome! Log In Create A New Profile

not sure what is causing this

Posted by Nikki81

Nikki81

not sure what is causing this
July 29, 2022 05:57AM

Registered: 9 years ago
Posts: 198

I am just tuning my ratrig build and it decided to try a vase mode print. The extruder steps are set perfectly and there is good layer cooling the rest of the print is fabulous its just the top shoulders and chest that there is a problem. I am using simplify3d 4.1

IMG_8106.jpg

Thanks Nikki

Edited 2 time(s). Last edit at 07/29/2022 06:18AM by Nikki81.

Reply Quote

VDX

Re: not sure what is causing this
July 29, 2022 06:25AM

Admin
Registered: 16 years ago
Posts: 13,886

... no or not enough support and to hot/soft, so its' sagging ...

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

Reply Quote

Nikki81

Re: not sure what is causing this
July 29, 2022 10:43AM

Registered: 9 years ago
Posts: 198

I found the fix. I reduced my layer Hight to 0.1000 after closely looking at the preview after slicing i could see that there were gaps.