Hi, all. Trying to get a polar printer set up. I run a g-code using a .cfg file with cartesian kinematics. keep everything the same, basically, when doing on .cfg with polar kinematics. Then I get the errors:
stepcompress o=0 i=0 c=57 a=0: Invalid sequence
Internal error on command:"G1"
I've attached my gcode, my successful .cfg, my unsuccessful .cfg, and my unsuccessful .cfg's klippy.log.
I'm running Klipper on Octoprint. This is a custom setup with a Raspberry Pi 4B, an Arduino Mega2560, and a RAMPs1.4. Printer parts custom. Unimportant, I think, but there it is. I slice using SuperSlicer.
Many thanks in advance.
Also posted on Reddit: [
www.reddit.com]
Edited 1 time(s). Last edit at 09/15/2022 03:46PM by WackoKacko.
