|
printing 90 degree edges - how to improve quality? (jerk, acceleration, oscillation) June 15, 2013 04:20AM |
Hi,
My prints are really great, but when it comes to a e.g. 90 degree turn the quality of my prints are really worse (please see attached pictures)
Is there anything I can improve in my firmware or at my Slic3r setting!?
( The first layer is perfect, so please don't focus on the 0,8mm extrusion with with a 0,4mm nozzle!
)
#######
Reprap
3mm ABS; 240°C hot end on 100°C glassbed
layer hight 0,15mm; 30% infill
2 perimeters
0,4mm nozzle
Sprinter firmware (latest)
Slic3r 0.9.9
printed part has a wall width of 1,5mm; two of them were on the printbed
Edited 2 time(s). Last edit at 06/15/2013 04:27AM by Irgendwer_Aus_Irgendwo.
My prints are really great, but when it comes to a e.g. 90 degree turn the quality of my prints are really worse (please see attached pictures)
Is there anything I can improve in my firmware or at my Slic3r setting!?
( The first layer is perfect, so please don't focus on the 0,8mm extrusion with with a 0,4mm nozzle!
)#######
Reprap
3mm ABS; 240°C hot end on 100°C glassbed
layer hight 0,15mm; 30% infill
2 perimeters
0,4mm nozzle
Sprinter firmware (latest)
Slic3r 0.9.9
printed part has a wall width of 1,5mm; two of them were on the printbed
Edited 2 time(s). Last edit at 06/15/2013 04:27AM by Irgendwer_Aus_Irgendwo.
|
Re: printing 90 degree edges - how to improve quality? (jerk, acceleration, oscillation) June 20, 2013 09:47AM |
hmmm - no one? 
Sorry, only registered users may post in this forum.