Multi-part printing issues February 25, 2014 11:28AM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues February 25, 2014 12:17PM |
Registered: 12 years ago Posts: 1,320 |
Re: Multi-part printing issues February 25, 2014 01:06PM |
Admin Registered: 11 years ago Posts: 3,096 |
Re: Multi-part printing issues February 25, 2014 02:30PM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues February 25, 2014 06:23PM |
Registered: 12 years ago Posts: 1,592 |
To measure the extrusion accurately you need to check it from the top of the the extruder, not the nozzle i.e. mark the filament,say 50mm above the entry point of the extruder and set repetier to extrude 50mm. The mark should stop at the entry point. If not, you need to re-calibrate.Quote
thefuzzbl
When I tell it to air extrude 10MM and measure the output it is 10MM. I have been using Slic3r and Repieter-Host for printing. The printer is running Marlin.
Suggestions?
Re: Multi-part printing issues February 25, 2014 07:31PM |
Admin Registered: 16 years ago Posts: 1,470 |
Help improve the RepRap wiki!
Just click "Edit" in the top-right corner of the page and start typing. Anyone can edit the wiki! |
Re: Multi-part printing issues February 25, 2014 08:40PM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues February 25, 2014 11:55PM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues February 26, 2014 07:32AM |
Registered: 11 years ago Posts: 466 |
Re: Multi-part printing issues February 26, 2014 10:40AM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues February 26, 2014 11:37AM |
Registered: 12 years ago Posts: 1,320 |
Re: Multi-part printing issues February 28, 2014 11:31PM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues March 01, 2014 04:37PM |
Admin Registered: 16 years ago Posts: 1,470 |
Help improve the RepRap wiki!
Just click "Edit" in the top-right corner of the page and start typing. Anyone can edit the wiki! |
Re: Multi-part printing issues March 01, 2014 10:28PM |
Registered: 11 years ago Posts: 14 |
Re: Multi-part printing issues March 04, 2014 02:10PM |
Registered: 11 years ago Posts: 553 |
Re: Multi-part printing issues March 19, 2014 01:52AM |
Registered: 11 years ago Posts: 14 |