Hello,
these days I have completed my Mendel printer after months of work
I made a small joystick to move all the motors and be sure to get fluid movements, its ok, all steppers works and i calibrated it.
..so i configured Marlin and uploaded it on arduino, and i can connect to 'him' with pronterface (Start button also works).
BUT, when i`m using pronterface, all motors (except extruder) wont move..! (then i cant move it to Home position or start printing)
No errors in output :/
wtf?
Using:
Windows 8.1
Arduino Mega
Ramps 1.4
Printer Model: Prusa Mendel i2
Slic3r
1x1cm cube model
Hope its the correct section, and im sorry if my english sucks
thx in advance
Edited 1 time(s). Last edit at 05/13/2014 04:41PM by TheTrigger.