Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 10, 2014 04:51PM |
Registered: 10 years ago Posts: 7 |
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 10, 2014 06:28PM |
Registered: 12 years ago Posts: 205 |
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 10, 2014 08:11PM |
Registered: 11 years ago Posts: 903 |
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 11, 2014 03:52AM |
Registered: 10 years ago Posts: 7 |
Hehe, yes, but don't worry I know it's making it worse, i tried to slow down but it only improves when reaching like 20% or 30%, it was for the needs of the video in order to see it better ^^Quote
vreihen
You're *really* pushing that poor mega2560 running with a speed multiplier of 201 on a Delta with a full graphics LCD!!!!!
Thank you for your answer.Quote
garyhlucas
...
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 11, 2014 07:01AM |
Registered: 11 years ago Posts: 903 |
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 11, 2014 07:36AM |
Registered: 10 years ago Posts: 7 |
Quote
vreihen
Marlin's handling of the GLCD is worse, according to other threads here .......... I can save a G-Code file directly to the printer's SD card in a few seconds from Cura, and run the job from any host software.....
Re: Kossel stuttering (not the steppers, not the g-code, and "not" starving) June 26, 2014 05:11PM |
Registered: 10 years ago Posts: 7 |