Welcome! Log In Create A New Profile

Definitive Guide to Solve Sloppy Print (Hair or String Problem)

Posted by shafri

shafri

Definitive Guide to Solve Sloppy Print (Hair or String Problem)
July 07, 2014 04:40PM

Registered: 10 years ago
Posts: 55

cheap soldering iron can do, but if you have more expensive such as temp control iron then its better. turn it on until it reach temperature, pass the iron through any unwanted string, they will dissapear like a whisper in the sky. thats it.

Reply Quote

Opus

Re: Definitive Guide to Solve Sloppy Print (Hair or String Problem)
July 07, 2014 07:02PM

Registered: 10 years ago
Posts: 62

I find just very quickly waving a butane torch over the object will make them vanish like magic as well.

Reply Quote

Dirty Steve

Re: Definitive Guide to Solve Sloppy Print (Hair or String Problem)
July 07, 2014 07:26PM

Registered: 12 years ago
Posts: 560

or you could tune your printer....just a suggestion.

Reply Quote

vreihen

Re: Definitive Guide to Solve Sloppy Print (Hair or String Problem)
July 07, 2014 08:18PM

Registered: 10 years ago
Posts: 903

...starting with the retraction distance and speed..... smiling smiley

Reply Quote

Opus

Re: Definitive Guide to Solve Sloppy Print (Hair or String Problem)
July 08, 2014 07:21PM

Registered: 10 years ago
Posts: 62

Quote
vreihen
...starting with the retraction distance and speed.....

Sometimes I find I end up walking a very fine line. Too much retraction and I get filament jams, too little and I get a tiny amount of very fine stringing. I'll take a quick wave of a torch over a ruined print smiling smiley