Extruder jam ?
July 29, 2014 11:14AM
Hi,

I think the attached video show an extruder jam ?

[www.youtube.com]

The stepper motor started ticking over during a print, and I tried to start print again which is on the video (and quickly turned it off).

I have just purchased the machine and is starting to learn about 3D printing, but the only thing I know is that it is a MendelMax1.5, but is not enough to do a detailed search on the extruder.

I use 3mm PLA, that is from the end of a roll, so it is very curved.

Should I increase extrusion temperature, currently at 185 degrees ?

I have made a successful print:

Re: Extruder jam ?
July 31, 2014 10:46AM
So I just got some new filament from Faberdashy.

What I have found is that when the print goes fast (long stretches of infill), the little herring wheel on the E motor starts moving out of the larger wheel, until it finally starts ticking over.
I can help it a little if I manually help turn the larger wheel.

Is my temperature too low, or ?

Thank you,
Re: Extruder jam ?
July 31, 2014 11:10AM
Tried raising the temperature from 185 to 195,... did not really help.
Re: Extruder jam ?
July 31, 2014 12:45PM
Just took the extruder apart.
One of the bearings was jammed, and the main axis could hardly turn.

Not related to printing, sorry.

Thank you,
Sorry, only registered users may post in this forum.

Click here to login