Dear All,
I am using Gen6 motherboard, slic3r program for G-code.
I got a problem when I print,
As you can see in below picture, there are webbing in each side.
It seems that printer didn't retraction when jump side to side.
So I adjusted retraction setting in slic3r program, but there are still on it.
How can I make this clean? I attached snap shoots for your understand.
Attachments:
open |
download -
_P20140803_101951239_69057E15-DF14-46CC-97D8-91D50D625816.JPG
(49.2 KB)