Strange behaviour on the first layer
October 18, 2014 03:23PM
The Print attached is the base layer of a rectangle that should be filled for the first layer.



Problem is, the border sticks very well to the bed as the print begins. The infill doesn't; it warps outward instead.

I changed Temperature from 185°C to 175°C during the last half of the layer (lower left corner). The bed temperature was set to 60°C material is PLA 0.4mm first layer hight.
Re: Strange behaviour on the first layer
October 20, 2014 05:36PM
Looks like your nozzle is a little too high. The filament isn't being smooshed down onto the print bed properly.


[3DKarma.com] - suppliers of quality, affordable 3D printer kits and filament for the UK market.
Sorry, only registered users may post in this forum.

Click here to login