my print lines aee zig-zag

Hello.as shown in picture i have some problem with printer. This is my 6 or7th printer but never before with problem like this.?

My printed line is not straight but goes micro zig zag motion. This happened after rewiring printer with new installation,so all components are fine. I assume that i have some problem with installation but cant figure where. It is noticeable on both x and y axis. I run ramps with 4988


Any ideas

Edited 1 time(s). Last edit at 10/27/2014 06:49PM by woo.

I think you have the z endstop too low. Try raising the z homing point so that the extrusion is squished, but the nozzle isn't touching the bed (.05-.1 mm gap).

Are you belts all tight?

---

T.S. Elliot wrote: "Between the idea and the reality, falls the shadow..." It's in that shadow world great discoveries are made.

Could is be electronic interference? User says it happened after rewiring?

---

http://www.marinusdebeer.nl/