Welcome! Log In Create A New Profile

Any idea on what's happening here ?

Posted by Walther

Walther

Any idea on what's happening here ?
November 07, 2014 01:53PM

Registered: 9 years ago
Posts: 37

Hi,

The second layer is not properly adhering to the bottom layer, and is pulled back with the nozzle.
This happen at all heights, but usually only for pointy edges. It was just very clear in this print.

Printed with PET T-Glase, 15mm/s, 190C, 0.5mm nozzle, 0.4mm layer, bed 60C ?

foto2.JPG

Thank you,

Edited 1 time(s). Last edit at 11/07/2014 01:57PM by Walther.

Reply Quote

Floyd

Re: Any idea on what's happening here ?
November 07, 2014 03:37PM

Registered: 10 years ago
Posts: 770

Might try bumping the heat a bit, I thought that stuff liked it more towards 212c?

Reply Quote

ggherbaz

Re: Any idea on what's happening here ?
November 07, 2014 04:53PM

Registered: 10 years ago
Posts: 1,401

Wow, wrong temperatures for t-glase (230~240 for hot end and 80~90 bed) and lower layer height to 0.3 , the speed is fine though.

Reply Quote

Walther

Re: Any idea on what's happening here ?
November 10, 2014 01:38PM

Registered: 9 years ago
Posts: 37

Thank you for the replies,

It helped raising the temperature.

The reason I had it low, was because I had a lot of oozing when initially heating the printer.
It would drain the nozzle, and I had to compensate with a lot of skirt/brim.

Thanks,

Reply Quote

pw3r

Re: Any idea on what's happening here ?
November 10, 2014 03:53PM

Registered: 9 years ago
Posts: 5

ciao a tutti , sono appena arrivato , uso una prusa mendel i3 . non riesco a capire il problema di questo cubo (^^ foto). abs 230-90 .gra

Reply Quote

Attachments:
open | download - 2014-11-10 21.51.11.jpg (351.5 KB)

pw3r

Re: Any idea on what's happening here ?
November 10, 2014 04:06PM

Registered: 9 years ago
Posts: 5

all 'interno è vuoto

Reply Quote

Attachments:
open | download - 2014-11-10 21.51.11.jpg (351.5 KB)

ggherbaz

Re: Any idea on what's happening here ?
November 11, 2014 07:35AM

Registered: 10 years ago
Posts: 1,401

scusi, no parlo Italiano.

You have several issues, from loose belts to over extrusion, you might be trying to print too fast.

I'll be better if you find someone that can parlare italiano with you and go through all the problems you have.

Ci vediamo

Reply Quote

pw3r

Re: Any idea on what's happening here ?
November 12, 2014 03:07PM

Registered: 9 years ago
Posts: 5

grazie