Hi guys,

I've been having some difficulty with layer becoming de-laminated during prints which you can see in this video -> [www.youtube.com]

At the end you can see my slicer setting I am using.

With thanks,

Kev

Is that ABS? If so, what are you using for bed adhesion?

---

_______________________________________
Waitaki 3D Printer

Looks more like PLA to me. If so is the fan on? What setting?

Ya its PLA. it was printing fine a few weeks earlier on the same fan settings but has only recently started to de-laminate. Where should I start with troubleshooting