Oh the pain!... August 15, 2015 06:13PM |
Registered: 9 years ago Posts: 61 |
Re: Oh the pain!... August 15, 2015 11:17PM |
Registered: 9 years ago Posts: 93 |
Re: Oh the pain!... August 16, 2015 05:29AM |
Registered: 9 years ago Posts: 61 |
Quote
Epop
ABS? If so... heated chamber or SUPER adhesive. Tape isn't going to hold it.
Most recommended IMO is "ABS slurry" or "ABS paste" (abs mixed with solvent)
I have broken prints in the middle and it still curls on the edges with adhesive... there does seem to be some tricks to it/specific combo. of heat/adhesive etc. It didn't work well for me, I went heat everywhere.
Re: Oh the pain!... August 16, 2015 06:32AM |
Registered: 9 years ago Posts: 61 |
Re: Oh the pain!... August 16, 2015 04:10PM |
Registered: 9 years ago Posts: 61 |
Re: Oh the pain!... August 18, 2015 08:24AM |
Registered: 10 years ago Posts: 22 |
Re: Oh the pain!... August 18, 2015 05:11PM |
Registered: 9 years ago Posts: 61 |
Re: Oh the pain!... August 23, 2015 01:19AM |
Registered: 9 years ago Posts: 93 |
Re: Oh the pain!... August 24, 2015 04:34PM |
Registered: 10 years ago Posts: 22 |
Quote
Epop
I print mostly ABS. my headache remover has been a controlled chamber heated to 60-80c.
HTH.
Re: Oh the pain!... August 25, 2015 01:08AM |
Registered: 9 years ago Posts: 150 |
Re: Oh the pain!... August 25, 2015 11:49AM |
Registered: 9 years ago Posts: 778 |
Re: Oh the pain!... August 28, 2015 09:36PM |
Registered: 9 years ago Posts: 183 |
Re: Oh the pain!... September 12, 2015 04:34PM |
Registered: 10 years ago Posts: 280 |
Re: Oh the pain!... September 12, 2015 11:01PM |
Registered: 9 years ago Posts: 93 |
Quote
dewasa
Quote
Epop
I print mostly ABS. my headache remover has been a controlled chamber heated to 60-80c.
HTH.
I am actually very curious about how you manage to make a heated chamber that can go up to 80 degrees. Did you find a way to have all your motors and all your electronic out of the chamber? Because I imagine that a stepper motor in 80 degrees air don't have a very long life expectancy
Re: Oh the pain!... September 13, 2015 04:21AM |
Registered: 10 years ago Posts: 893 |
Re: Oh the pain!... September 13, 2015 07:52AM |
Registered: 10 years ago Posts: 280 |
Re: Oh the pain!... September 13, 2015 10:27AM |
Registered: 9 years ago Posts: 61 |
Re: Oh the pain!... September 13, 2015 12:43PM |
Registered: 11 years ago Posts: 14,685 |
Quote
KillerDave
Do I need to reset my print gap after every print??? What a chore!
Re: Oh the pain!... November 13, 2015 12:14PM |
Registered: 9 years ago Posts: 61 |