Prusa i3 uneven layers and gaps PLA

Every pla print will come out like this no matter the layer height. I have tried temps from 180-210. All my axis are calibrated. I have no idea what could be causing these gaps. Extrusion multiplier is also fine since I printed a single walled cube and calibrated it. These gaps were not present in the single walled cube.

Please don't double post your problems...

THX
-Olaf

What is your print speed, you could be printing the infill too fast.

It’s been a while, but were you able to find a solution to this? I am experiencing the same problem right now.