Filament Runout Sensor without LCD-Panel?
December 08, 2015 06:11AM

I am wondering if there is any way to use a Filament runout sensor without an LCD-Panel.
My firmware (Marlin 1.0.3) already has a function for this (M600), but it only works in combination with a LCD-Panel.
I would like to have a solution to use a filament runout sensor with my host-PC (Simplify3D or Repetier-Host). So far I havent found a working solution.
I have added a sensor and set the pins.h accordingly. I just ran out of ideas about what should happen, once the sensor is activated (filament runout).

Any ideas/Solutions?

Thanks in advance
Sorry, only registered users may post in this forum.

Click here to login